Revolabs HD Single & Dual Channel System — Polycom VSX Instrukcja Użytkownika Pobierz pdf

Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide

This setup guide will guide you through the steps needed to properly connect a

Revolabs HD Single or Dual Channel System to a Polycom VSX 8000 video codec.

Note:

It is important to carefully follow these instructions in order and completely.

Otherwise your Revolabs Microphone System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System

2. Polycom VSX 8000 video codec

3. QTY 1 3.5mm balanced male connector to 3-pin mini Phoenix connector

cable*

* 07-35MBTOMPHX-01 6’ 3.5mm balanced male connector to 3-pin mini

Phoenix connector cable available from Revolabs

3.5MM STEREO MALE TO PHOENIX CONNECTOR CABLE DIAGRAM

Revolabs either recommends using the Revolabs 07-35MBTOMPHX-01 6’ 3.5mm balanced

male connector to 3-pin mini Phoenix connector cable, or cutting the end off an 1/8” cable and

attaching the green Phoenix connector as shown above.

1 2

Strona 1

Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide This setup guide will guide you through the steps needed to properly connect

Connecting the Cables 1. Insert the balanced 3.5mm male connector to the CH 1 OUT port on the Single or Dual Channel System. If using a Single Chann

Więcej dokumentów dla Ekwipunek Revolabs HD Single & Dual Channel System — Polycom VSX

Brak uwag